Siemens SID211 remap
2.0 TDCI 105 BHP Siemens SID211 EU6 Ford Transit Custom
2016–2019 2.0 TDCI 105 Diesel Siemens SID211
Stock 105BHP 360Nm
Stage 1 205BHP 460Nm
Gain +100BHP +100Nm
Stage 1 remap incl. OBD programming tool £330
Buy now · £330 - 1Read ECU over OBD
- 2Files sent by email
- 3Program yourself
- All tuning is developed in house - over 15 years of experience
S1
Stage 1
205BHP+100
460Nm+100
Stage 1 is designed to run on standard components, with no hardware upgrades required. Our calibrations are developed and tested in house. We focus on smooth, strong, progressive power delivery.
Drivability, economy and reliability are key. We aim to maximise power while staying within the safe limits of your engine.
On vehicles with an automatic gearbox, you can rest assured that gear changes stay smooth and seamless. Because we correctly edit the torque model in the engine ECU, the transmission control unit (TCU) can make use of the extra low-end torque and calculate the optimal point to shift up or down. The TCU also shifts down less often when the torque model shows that power is available, which makes the vehicle much nicer to drive and you won't be interrupted by unwanted kickdown unless it's actually required or if you specifically hit the kickdown point.
Drivability, economy and reliability are key. We aim to maximise power while staying within the safe limits of your engine.
On vehicles with an automatic gearbox, you can rest assured that gear changes stay smooth and seamless. Because we correctly edit the torque model in the engine ECU, the transmission control unit (TCU) can make use of the extra low-end torque and calculate the optimal point to shift up or down. The TCU also shifts down less often when the torque model shows that power is available, which makes the vehicle much nicer to drive and you won't be interrupted by unwanted kickdown unless it's actually required or if you specifically hit the kickdown point.
Stage 1 vs stock See the dyno chart ↑
Power +95%
105 205 BHP
Stock 105S1 205 (+100)
Torque +28%
360 460 Nm
Stock 360S1 460 (+100)
Siemens SID211
Programming method
Programming via OBD – Siemens SID211
- Install the MyGenius software to your PC and initialise the tool.
- Connect battery charger or battery stabiliser to the vehicle battery. Remove or disconnect any ancillaries that draw power before you start programming.
- Connect MyGenius to the OBD port of your Vehicle.
- ID the ECU and follow the instructions on the MyGenius device.
- Connect the tool back to your computer, email the software read out to remap@hdi-tuning.co.uk along with a description of the remap you require.
- We will modify the software and send it back to you. This normally takes less than 2 to 3 hours during workdays.
- Using the same tool, connect to the ECU and follow the instructions.
- Let your engine warm up and then take the van for a spin. Enjoy the extra power!
More Ford
Other Ford remaps
Stage 1 incl. tool £330 Buy now