remap@hdi-tuning.co.uk Contact us Book appointment
Siemens SID211 remap

2.0 TDCI 170 BHP Siemens SID211 EU6 Ford Transit Custom

2016–2019 2.0 TDCI 170 Diesel Siemens SID211
Stock 170BHP 405Nm
Stage 1 205BHP 460Nm
Gain +35BHP +55Nm
Power (BHP) Torque (Nm) Stock Stage 1 dyno
250 550 200 440 150 330 100 220 50 110 0 0 10002000300040005000 RPM 460 Nm 205 BHP
Recommended tool Dimsport MyGenius: flash this car over OBD yourself
Stage 1 remap incl. OBD programming tool £330
Buy now · £330
  1. 1Read ECU over OBD
  2. 2Files sent by email
  3. 3Program yourself
  • All tuning is developed in house - over 15 years of experience
S1

Stage 1

205BHP+35
460Nm+55
Stage 1 is designed to run on standard components, with no hardware upgrades required. Our calibrations are developed and tested in house. We focus on smooth, strong, progressive power delivery.

Drivability, economy and reliability are key. We aim to maximise power while staying within the safe limits of your engine.

On vehicles with an automatic gearbox, you can rest assured that gear changes stay smooth and seamless. Because we correctly edit the torque model in the engine ECU, the transmission control unit (TCU) can make use of the extra low-end torque and calculate the optimal point to shift up or down. The TCU also shifts down less often when the torque model shows that power is available, which makes the vehicle much nicer to drive and you won't be interrupted by unwanted kickdown unless it's actually required or if you specifically hit the kickdown point.
Stage 1 vs stock
Power +21%
170 205 BHP
Stock 170S1 205 (+35)
Torque +14%
405 460 Nm
Stock 405S1 460 (+55)
See the dyno chart ↑
Siemens SID211

Programming method

Programming via OBD – Siemens SID211

  • Install the MyGenius software to your PC and initialise the tool.
  • Connect battery charger or battery stabiliser to the vehicle battery. Remove or disconnect any ancillaries that draw power before you start programming.
  • Connect MyGenius to the OBD port of your Vehicle.
  • ID the ECU and follow the instructions on the MyGenius device.
  • Connect the tool back to your computer, email the software read out to remap@hdi-tuning.co.uk along with a description of the remap you require.
  • We will modify the software and send it back to you. This normally takes less than 2 to 3 hours during workdays.
  • Using the same tool, connect to the ECU and follow the instructions.
  • Let your engine warm up and then take the van for a spin. Enjoy the extra power!
More Ford

Other Ford remaps