remap@hdi-tuning.co.uk Contact us Book appointment
Bosch EDC16C31 remap

D5 2.4D 180 BHP Bosch EDC16

2005–2010 D5 2.4D 185 Diesel Bosch EDC16C31
Stock 180BHP 350Nm
Stage 1 223BHP 495Nm
Gain +43BHP +145Nm
Power (BHP) Torque (Nm) Stock Stage 1 dyno
275 600 220 480 165 360 110 240 55 120 0 0 10002000300040005000 RPM 511 Nm 225 BHP
Recommended tool Dimsport MyGenius: flash this car over OBD yourself
Stage 1 remap incl. OBD programming tool £330
Buy now · £330
  1. 1Read ECU over OBD
  2. 2Files sent by email
  3. 3Program yourself
  • All tuning is developed in house - over 15 years of experience
HDI Tuning have carried out extensive testing and development work on the Volvo D5 engine, we now have available perfectly fine tuned software which is on a much higher quality level than our competitors are offering for this engine. We can also offer stage 2 software, Flaps delete and anything else you might need including custom work, MAP sensor upgrades, rev limiters, just let us know what you want.
S1

Stage 1

223BHP+43
495Nm+145
Our Stage 1 remap gives 223BHP and a torque increase to 495Nm. We've developed this remap not only to give optimal performance, but also to remain within the limits of the stock hardware of your vehicle so you don't need to worry about your clutch or your dual mass flywheel. Power delivery will be smooth and constant through the entire rpm range and will make overtaking much easier. Most of the Volvo D5 2.4D 180 engines come fitted with a DPF system, we’ve developed this remap to run clean and smoke free by maintaining higher AFR like the factory setup, as such there’s no increased risk of the particle filter clogging when running our Stage 1 remap. Most customers also see an economy gain during normal driving conditions when running a stage 1 remap.
Stage 1 vs stock
Power +24%
180 223 BHP
Stock 180S1 223 (+43)
Torque +41%
350 495 Nm
Stock 350S1 495 (+145)
See the dyno chart ↑
Bosch EDC16C31

Programming method

Programming Methods – OBD - MyGenius

Program from home over OBD using MyGenius. The only equipment you need is a battery charger to keep the vehicle power stable. A laptop is required to initialise the MyGenius tool, it is not used during programming. The tool is standalone and powered from the OBD port.

When you receive the tool, scan the QR code to download the software.
Connect the tool via USB to your computer and initialise the tool.
Now connect your battery charger to the vheicle battery, MyGenius to the OBD port.
Follow the on screen instructions to extract the data from the ECU.
Connect to the PC, send us the file, we remap and send it back.
Add the file to the tool with the computer, move back to the car and connect charger, connect MyGenius to the OBD port.
Follow the on screen instructions to program the ECU.

Programming via Bench service mode

Bosch EDC16 and EDC17 ECUs can be programmed in bench service mode without opening the ECU. This is the method we use when you send us your ECU using the postal remapping service. A full backup can be made of both the EEPROM and the internal flash memories.

Programming via BDM port or Boot mode with bench tool.

This is an old method with an open ECU, a boot pin must be connected to the board. We avoid this except for recovery when there is no comms in bench service mode.
More Volvo

Other Volvo remaps