remap@hdi-tuning.co.uk Contact us Book appointment
Bosch EDC17C74 remap

Skoda Superb (3V) 2.0 TDI 187 BHP 2015-2023 Stage 1 Remap

2015–2023 2.0 TDI Diesel Bosch EDC17C74
Stock 187BHP 400Nm
Stage 1 230BHP 525Nm
Gain +43BHP +125Nm
Power (BHP) Torque (Nm) Stock Stage 1 dyno
275 650 220 520 165 390 110 260 55 130 0 0 10002000300040005000 RPM 525 Nm 230 BHP
Recommended tool Dimsport MyGenius: flash this car over OBD yourself
Stage 1 remap incl. OBD programming tool £330
Buy now · £330
  1. 1Read ECU over OBD
  2. 2Files sent by email
  3. 3Program yourself
  • All tuning is developed in house - over 15 years of experience
S1

Stage 1

230BHP+43
525Nm+125
Stage 1 is designed to run on standard components, with no hardware upgrades required. Our calibrations are developed and tested in house. We focus on smooth, strong, progressive power delivery.

Drivability, economy and reliability are key. We aim to maximise power while staying within the safe limits of your engine.

On vehicles with an automatic gearbox, you can rest assured that gear changes stay smooth and seamless. Because we correctly edit the torque model in the engine ECU, the transmission control unit (TCU) can make use of the extra low-end torque and calculate the optimal point to shift up or down. The TCU also shifts down less often when the torque model shows that power is available, which makes the vehicle much nicer to drive and you won't be interrupted by unwanted kickdown unless it's actually required or if you specifically hit the kickdown point.
Stage 1 vs stock
Power +23%
187 230 BHP
Stock 187S1 230 (+43)
Torque +31%
400 525 Nm
Stock 400S1 525 (+125)
See the dyno chart ↑
Bosch EDC17C74

Programming method

Programming Methods – OBD - MyGenius

Program from home over OBD using MyGenius. The only equipment you need is a battery charger to keep the vehicle power stable. A laptop is required to initialise the MyGenius tool, it is not used during programming. The tool is standalone and powered from the OBD port.

When you receive the tool, scan the QR code to download the software.
Connect the tool via USB to your computer and initialise the tool.
Now connect your battery charger to the vheicle battery, MyGenius to the OBD port.
Follow the on screen instructions to extract the data from the ECU.
Connect to the PC, send us the file, we remap and send it back.
Add the file to the tool with the computer, move back to the car and connect charger, connect MyGenius to the OBD port.
Follow the on screen instructions to program the ECU.

Programming via Bench service mode

Bosch EDC16 and EDC17 ECUs can be programmed in bench service mode without opening the ECU. This is the method we use when you send us your ECU using the postal remapping service. A full backup can be made of both the EEPROM and the internal flash memories.

Programming via BDM port or Boot mode with bench tool.

This is an old method with an open ECU, a boot pin must be connected to the board. We avoid this except for recovery when there is no comms in bench service mode.
More Skoda

Other Skoda remaps